The other two are on found on the bottom of the battery.

To clean the dust canister, you first want to remove the cyclones so that you can give it a deep clean.You do this by pressing down on the latch at the top of the cyclone, then using a button on the side of the canister to release the cyclones.. Once you have separated the dust canister, you should.

use a damp cloth to clean inside.Dyson instructs that you shouldn’t use any detergents or air fresheners for the canister..When you’ve finished cleaning the canister, take a look at the cyclones..

There is a thin mesh that goes around the cyclones that can often get clogged with fluff.If this is the case, use a soft, damp cloth to gently remove it to restore suction.. Make sure the canister and cyclones are fully dry before you reassemble the vacuum cleaner..

The cyclones should never be immersed in water or even run under a tap.

Only use a damp cloth to clean them..Step 2: Remove the Base Plate.

Make sure your vacuum is switched off and unplugged before attempting to replace the belt!.As the vacuum belt turns the brush bar, you’ll need to access this area.

Start by tilting the vacuum onto its back, then removing the base plate.. You’ll probably need a screwdriver to remove the plate and get full access to the brushroll area..Step 3: Remove the Brush Bar (if Necessary) and Broken Belt.